shark vacuum cleaner how to remove brush

Removing the brush roll from your Shark vacuum cleaner can vary slightly depending on the model, but here are general steps you can follow:

Steps to Remove the Brush Roll

  1. Turn Off and Unplug: Ensure the vacuum is turned off and unplugged for safety.

  2. Access the Brush Roll:

    • For Upright Models: Lay the vacuum down to access the underside.
    • For Lift-Away Models: Detach the canister from the floor nozzle if applicable.

  3. Locate the Brush Roll Release:

    • Look for screws or a release latch. Some models have a cover that needs to be removed.

  4. Remove Screws (if applicable):

    • Use a screwdriver to remove any screws securing the brush roll cover.

  5. Release the Brush Roll:

    • If there’s a latch, press or pull it to free the brush roll.
    • For some models, you may need to pull the brush roll out directly.

  6. Clean or Replace:

    • Once removed, you can clean the brush roll of any hair or debris, or replace it if necessary.

Reinstalling the Brush Roll

  1. Insert the Brush Roll: Slide the brush roll back into its housing.

  2. Secure the Cover: If applicable, replace the cover and secure it with screws.

  3. Test the Mechanism: Make sure the brush roll spins freely before using the vacuum again.

Tips

  • Refer to the Manual: Always check your specific model’s manual for detailed instructions, as designs can differ.
  • Keep Track of Parts: Keep any screws or small parts in a safe place during the process.

Following these steps should help you successfully remove and clean or replace the brush roll in your Shark vacuum!

Back to blog